CLI Reference
Configuration Tutorials
B-16
SpectraComm IP Router Card
076R200-000
Installation and Operation Manual
Issue 2
Configure the “Remote” SC-IP
1. Attach the hyperterminal to the craft port of the SC-IP that represents the remote site unit.
2. After the initializing sequence, set the system prompt for the remote unit by typing:
configure prompt "REM_SC-IP"
3. Configure the T1 values for the SC-IP for your network. If the SC-IP’s T1 default values
(shown below) apply to your network, you do not need to re-enter them. Otherwise, use the
CLI to set any T1 configuration value as required. Type
?
following any command, sub-
command or parameter for context-sensitive online help.
configure t1 clock-source line
configure t1 fdl ANSI-T1.403
configure t1 framing ESF
configure t1 lbo ds1 0.0dB
configure t1 linecode B8ZS
configure t1 loopback INHIBIT
configure t1 timeslots 1-24
4. Type
show T1
to check the T1 current values. Modify, if needed.
5. Configure and enable the Ethernet0 interface, IP address and IP mask by typing:
configure interfaces enable ethernet0
6. Configure and enable the serial0 interface for LAN-X mode and for inband management by
typing:
configure interfaces link-encap serial0 lanx
configure interfaces ip-address serial0 172.16.5.10 255.255.0.0
configure interfaces enable serial0
7. Configure serial0 interface for LAN-X Management by typing:
configure lanx-router mgt serial0
8. You have completed the configuration of the remote SC-IP in LAN-X mode in the example
network. You can check your settings with the following two techniques:
•
Type
show config
to display the current configuration of the SC-IP.
•
Test your example network by pinging from your PC/workstation at the NOC to
equipment at the remote office, and vice-versa.