![background image](http://html1.mh-extra.com/html/general-datacomm/sc-ip/sc-ip_installation-and-operation-manual_2210289064.webp)
Application Guidelines
SC-IP Default Configurations
A-2
SpectraComm IP Router Card
076R200-000
Installation and Operation Manual
Issue 2
SC-IP Default Configurations
SC-IP is shipped from the factory with the ordered Default Profile that most suits the customer
application. The Profile establishes default values for most configurable settings required by SC-IP
in router mode or LAN-X modes.
Table A-1
describes Default Configuration Profile #1. Your
factory defaults may vary, depending on which profile was ordered with your unit.
Users can change values from the default setting via Supv or Admin access to the CLI or the web
interface. The Default Profile can be reloaded back into a SC-IP whenever a “clean baseline” is
desirable prior to downloading a batch file configuration. To accomplish this, type
default all
at the command prompt, or add the
# default all
command uncommented at the start of
your configuration batch file. You may need to reboot the unit.
Table A-1
Default Configuration Profile #1 (GDC P/N 076U032-D01)
Setting
Default
Setting
Default
System Prompt
SC-IP
Serial0 Interface
Link-encapsulation serial0
Frame Relay DTE
Inactivity Timer
900 seconds
LMI type cisco
HTTP Service
Disabled
LMI n391 6
SNMP Service
Disabled
LMI n392 3
T1 Configuration
LMI n393 4
Clock-source line
LMI t391 10
FDL ANSI-T1.403
Disabled serial 0
Framing ESF
Serial1 Interface
Link-encapsulation serial1
Frame Relay DTE
LBO DS1 0.0db
LMI type cisco
Line Code B8ZS
LMI n391 6
Loopback Inhibit
LMI n392 3
Timeslots 1 - 24 64
LMI n393 4
Ethernet0 Interface
Disabled
LMI t391 10
Modem0 Interface
192.168.11.220 255.255.255.0
Disable serial 1
Modem Enabled
Terminal Server
term1 9600 8 N 1, Disabled
AUX interface
192.168.11.230 255.255.255.0
term2 9600 8 N 1, Disabled
AUX Enabled
term3 9600 8 N 1, Disabled
LAN-Extension
LANX-router mgt-None
term4 9600 8 N 1, Disabled
SNMP Configuration Community add public ro en
term5 9600 8 N 1, Disabled
Name “YOUR SYSTEM NAME”
term6 9600 8 N 1, Disabled
Contact “YOUR SYSTEM CONTACT”
term7 9600 8 N 1, Disabled
Location “YOUR SYSTEM LOCATION”
term8 9600 8 N 1, Disabled
User Accounts
Configuration
Add admin
Escape sequence ^^^
Add supervisor
Auto Reboot
Disabled
To enable, uncomment the
batch file line:
# reboot
Add gdc
Console (craft port)
Authentication Disabled
Spanning Tree
Disabled