Installation & Connections
Shelf and Card Connections
076R200-000
SpectraComm IP Router Card
2-7
Issue 2
Installation and Operation Manual
Craft Port (DCE Interface)
(Interface “D” in
Figure 2-1
)
The SC-IP Front Panel Craft (or console) port is an RS-561-compatible RJ45 jack that supports
9600bps asynchronous data. It provides terminal interface control of the unit by direct connection
to a local VT100-compatible ASCII terminal. Connection to the Craft port requires an RJ45-to-
RJ45 cable (GDC P/N 830-128-007 and GDC P/N 029H210-001 or 029H211-001). The table
below describes the Craft port pinouts
Ethernet (LAN) Ports
(Interface “E” in
Figure 2-1
)
The SC-IP Front Panel LAN ports support 10/100BASE-T Ethernet connectivity. This port requires
an RJ45-to-RJ45 straight-thru or crossover cable (GDC S-078H010-XXX or S-078H011-XXX).
The table below describes Ethernet port pinouts.
Table 2-6
Craft Port Pinouts (DCE Interface)
Pin
Signal
Direction
Description
1
No Connection
-
-
2
DCD
From SC-IP
Data Carrier Detect - Always on
3
DTR
To SC-IP
Data Terminal Ready - Not used
4
Signal Ground
-
Signal Ground
5
RXD
From SC-IP
Receive Data - Supervisory data to the terminal
6
TXD
To SC-IP
Transmit Data - Supervisory data from the terminal
7
CTS
From SC-IP
Clear To Send - Always on
8
RTS
To SC-IP
Request To Send From the terminal
Table 2-7
Ethernet LAN Port 1 & Port 2 Pinouts
Pin Signal
Direction
Description
1
Rx+
To SC-IP
Receive Data
2
Rx-
To SC-IP
Receive Data
3
Tx+
From SC-IP
Transmit Data
6
Tx-
From SC-IP
Transmit Data
