![background image](http://html1.mh-extra.com/html/general-datacomm/sc-ip/sc-ip_installation-and-operation-manual_2210289045.webp)
SC-IP Configuration
Configuring SC-IP with Smart CLI
076R200-000
SpectraComm IP Router Card
3-11
Issue 2
Installation and Operation Manual
7. Configure the ethernet0 interface for LAN-X management by typing:
configure lanx-router mgt ethernet0
8. Configure and enable the serial0 interface for LAN-extension mode by typing:
configure interfaces link-encap serial0 lanx
configure interfaces enable serial0
9. Configure Terminal Server Ports 1 through 8 as needed by typing:
configure term-serv ip-address term
[#]
[###.###.###.###]
configure term-serv description term
[#]
[your_description]
10. Enable each configured Terminal Server Ports by typing:
configure term-serv enable term
[#]
11. You have completed the configuration of the NOC SC-IP in LAN-extension mode, for a flat
(no routing) network environment. You can check your settings with the following two
techniques:
•
Type
show config
to display the current configuration of the SC-IP.
•
Test your example network by pinging from your PC/workstation at the NOC to
equipment at the remote office, and vice-versa.
Configure the Remote SC-IP
12. Attach the hyperterminal to the craft port of the remote SC-IP unit.
13. After the initializing sequence, set the system prompt for the remote unit by typing
configure prompt
[your_REM_site]
14. Configure the T1 values for your network.
configure t1 clock-source
[line]
configure t1 fdl
[ANSI-T1.403]
configure t1 framing
[ESF]
configure t1 lbo ds1
[0.0dB]
configure t1 linecode
[B8ZS]
configure t1 loopback
[INHIBIT]
configure t1 timeslots
[1-24 64]
configure span-tree
[enable]
Note
When configuring the Line Buildout for DSX1, SC-IP uses five ranges of lengths: 0 - 133 ft, 133-266 ft,
266-399 ft, 399 - 533 ft, 533-655 ft. Be aware that if you select a value at the beginning of a range, such as
133 ft, SC-IP will use the lower range that includes that value.
Note
Once spanning tree is enabled, additional configurable options are available for that function. Do not change
these additional spanning tree options from the default settings unless you have a comprehensive
understanding of the spanning tree protocol. (Ref. IEEE 802.1D)