Introduction and Specifications
The SC-IP Front Panel
1-6
SpectraComm IP Router Card
076R200-000
Installation and Operation Manual
Issue 2
The SC-IP Front Panel
Table 1-1
describes the front panel connectors and indicators on the SC-IP Router card.
Figure 2-1
describes the SC-IP rear panel as deployed in a SpectraComm shelf or enclosure system.
Physical features that support DDS and Modem facilities are implemented in a future release.
Table 1-1
SC-IP Card Front Panel
SC-IP Front Panel
LEDs / Ports
Description
Action
ON
On (GREEN) indicates SC-IP is receiving power.
INS
On (GREEN) indicates SC-IP is ready for operation.
MODEM TX
-Future Use-
Off
No send data present at the Modem port.
On (GREEN)
Indicates Send Data frames are present at the Modem port.
MODEM RX
-Future Use-
Off
No Receive Data present at the Modem port.
On (GREEN)
Indicates the presence of data frames at the Modem port,
received from the remote modem.
T1 TX
Off
No data is being sent out at T1 Network port.
On (GREEN)
Indicates Send Data frames are present at the T1 Network
port.
T1 RX
Off
No Receive Data present at the T1 Network port.
On (GREEN)
Indicates data present at the T1 port, originating from the
Network.
AUX TX
-Future Use-
Off
No send data present at the AUX port.
On (GREEN)
Indicates Send Data frames are present at the AUX port.
AUX RX
-Future Use-
Off
No Receive Data present at the AUX port.
On (GREEN)
Indicates Receive Data frames present at the AUX port.
ALM
-Future Use-
Off
Normal conditions.
On (RED)
Indicates T1 Network alarm (AIS, RAI, or LAD).
TM
-Future Use-
Off
Indicates normal operating conditions.
On (RED)
Indicates SC-IP is in Test Mode, performing a diagnostic test.
Craft Port
RS-561-compatible jack for direct connection of the unit to a local
VT100-compatible ASCII terminal.
Ethernet Port 1
Each Ethernet port supports
10/100Base-T connectivity.
Ethernet Port 2
Ethernet LEDs
(1 and 2)
Off
Ethernet port 1 or 2 is not connected
On (STEADY)
Steady On (GREEN) indicates the Ethernet port (1 or 2) is
connected and not passing data.
ON (BLINKING) Blinking On (GREEN) indicates the Ethernet port (1 or 2) is
connected and actively passing data.
SC-IP E1
INS
ON
MODEM
T
X
R
X
E1
AUX
TM ALM
C
R
A
F
T
P
O
R
T
1
ETHERNET
1
2
P
O
R
T
2