![background image](http://html1.mh-extra.com/html/general-datacomm/sc-ip/sc-ip_installation-and-operation-manual_2210289039.webp)
SC-IP Configuration
Configuring SC-IP with Smart CLI
076R200-000
SpectraComm IP Router Card
3-5
Issue 2
Installation and Operation Manual
8. Enable the serial0 interfaces by typing:
configure interfaces enable serial0
9. Configure the serial0 sub-interface to support Frame Relay DLCIs by typing:
configure interfaces add-sub serial0.
[##]
configure interfaces description serial0.
[##]
[your_description]
10. Enable the s0 sub-interface by typing:
configure interfaces enable serial0.
[###]
Note
Type
show interfaces
to check your interface entries. Modify, if needed.
11. Map Frame Relay DLCIs, IP Encapsulation to sub-interfaces by typing:
configure frame-relay interface-dlci serial0.
[##]
[##]
[ietf]
12. Configure Traffic Shaping per sub-interface by typing the CIR, Bc and Be values. The values
you enter must be consistent with how your Frame Relay network has been configured. Type:
configure frame-relay traffic-shape serial0.
[##]
[###### ###### ######]
configure frame-relay ena-traffic serial0.
[##]
13. Enable Traffic Shaping by typing:
configure frame-relay ena-traffic serial0.
[##]
14. Configure Terminal Server Ports 1 through 8 as needed by typing:
configure term-serv ip-address term
[#]
[###.###.###.###]
configure term-serv description term
[#]
[your_description]
15. Enable each configured Terminal Server Ports by typing:
configure term-serv enable term
[#]
16. Set up static routes for the Frame Relay network by typing:
configure ip-route add serial0.17
[destination IP] [destination mask]
[next hop/gateway] [metric]
Note
When setting up static routes, type the short-cut
conf ip a ?
to get a list of all required arguments.
17. You have completed the configuration of the SC-IP for a Frame Relay DTE network
environment. You can check your settings with the following two techniques:
•
Type
show config
to display the current configuration of the SC-IP.
•
Test your example network by pinging from your PC/workstation at the NOC to
equipment at the remote office, and vice-versa.