
SBI-DN
57
——————
Interface Board DeviceNet
——————
Enter(S->M/M->S) POLL pressed
Password enabled
or active ?
Channel exceed
configuration data
Enter password
Password OK ?
Enter drive parameter
Send to the drive
Drive reply OK ?
Exit
Warning
Warning
Warning
Exit
Exit
Exit
yes
no
yes
Save in E2PROM
no
no
yes
yes
no
The validity of the specified Drive parameters is checked by the Drive.
If the Drive returns with an error code, the following message will be displayed on
the keypad:
Par. not assign.
Err. code: XXXXh
TSB8040
The error code generated by the Drive is displayed in hexadecimal format; error
codes are listed in chapter 6.0.
If data entry is correct, the following message will be displayed:
ENTER OK !
TSB8050
This message automatically disappears after two seconds, or upon pressing the
Cancel key.
Refer to chaper 7.6.1 for messages regarding Password entry.