Servicing the PT878GC
9-29
April 2009
Setting up Measurement Mode (cont.)
The first prompt asks for the measurement mode detection
method. Use the [
W
] and [
X
] arrow keys to move to the
appropriate radio button and press
[ENTER]
.
You must now enter the setup data covered on page 4-23, if you
have not already done so. Pressing the [
T
] key takes you to
“Skan/Measure Setup.” Press
[ENTER]
to open the Skan/Measure
option and enter the parameters discussed on page 4-23.
You have completed entering data for the Measurement Mode. To
leave this window,
•
Press the [
S
] key to return to the Measurement Mode tab,
and the [
W
] arrow key to move to the Signal Parameter tab
or the [
X
] arrow key to move to the Pulse/Code tab.
•
Press
[F2]
(Cancel) to return to Operate Mode without
confirming the changes.
•
Press
[F3]
(OK) to confirm the new data and return to
Operate Mode.
Содержание TransPort PT878GC
Страница 1: ...GE Sensing Inspection Technologies TransPort PT878GC Portable Gas Flowmeter User s Manual ...
Страница 29: ...Initial Setup 2 13 April 2009 Keypad cont Figure 2 7 The TransPort PT878GC Keypad ...
Страница 208: ...April 2009 9 4 Servicing the PT878GC Printing Reports cont Figure 9 3 Printout of a Typical Drive Report ...