GAC MOTOR GS3, Руководство пользователя

Страница: 177 / 261

171
5. Driving guide
EPS indicator lamp
With ignition switch set in “ON” position, the
indicator lamp
comes on, and if it goes out
several seconds after the engine is started, it
means that the system has passed the self-
test and no fault is found.
If the indicator lamp
does not go out after
the engine is started or comes on during
driving, it indicates that the EPS is faulty, and
in the meanwhile, an alarm message will be
displayed on the instrument cluster display. In
this case, it is required to park the vehicle in
a safe place, and shut down and restart the
engine. If the indicator lamp does not go out
or comes on again during driving, stop driving,
and contact the GAC Motor authorized shop
for inspection.
Steering mode
There are three steering modes: Standard,
Sport and Comfort modes, where the hand
force of the driver turning the steering wheel
in Sport mode will be a little greater than that
in the Standard mode, and the hand force in
Comfort mode will be a little smaller than that
in the Standard mode, and the system is set
to the Standard mode by default. For setting
of steering mode, click “System Settings
→ Driving Assistance → Lateral Driving
Assistance → Steering Mode” in the AV
system.
CAUTION
● The steering mode cannot be switched
when the steering wheel is turned.
● To prevent an accident, never set the
steering mode during driving.
5.7 Driving skills
5.7.1 Pre-driving safety
inspection
Routine inspection
- Check the tire for high/low pressure, cuts,
bulges, damage or excessive wear.
- Check whether the wheel studs are
missing or loose.
- C h e c k w h e t h e r t h e f r o n t & r e a r
combination lamps and other lamps work
properly; check the lighting direction of the
front combination lamp.
- Check that the seat belt is not worn or
damaged; check that the seat belt is
fastened securely after fastening the seat
belt.
- Check that the free travel of the pedal is
sufficient.
- Check whether the levels of coolant,
engine oil, brake fluid and windshield
washer fluid are normal.
- Check the battery terminals for corrosion
or looseness, and check the battery case
for cracks or deformation caused by
expansion.
- Check for leakage of fuel, engine oil,
water or other fluids under the vehicle,
and pay attention that water drip found
after A/C operation is normal.