FULTON ModSync SE, Руководство пользователя

Страница: 58 / 79

© Fulton Group N.A., Inc. 2021
4-4
NETWORK
ModSyncSE-User-Manual-211020
SECTION 4
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
Boiler Modbus Network (Port 3)
Port 3 from the ModSync® is used for Modbus communication to the boilers.
Depending on the setup this can include LMV3, LMV5, SOLA, or other boiler
controls. The option to toggle between available controllers is located on the
ModSync® initial startup page and typically only needs to be preset / selected
once at the factory.
ƒ
Modbus Wiring:
The Modbus communication wiring should be done in a
daisy chain configuration. The wiring should be three wire shielded. The
shield should be connected to earth ground at the ModSync® only.