FULTON ModSync SE, Руководство пользователя

Страница: 44 / 79

© Fulton Group N.A., Inc. 2021
3-30
OPERATION
ModSyncSE-User-Manual-211020
SECTION 3
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
ƒ
Lead / Lag Configuration 2
ƒ
Lag Boiler Start Delay: Defined in units of Minutes/Seconds. Determines
the time required before the ModSync® will enable a lag boiler after it has
reached its enable point.
ƒ
Lag Boiler Stop Delay:
Defined in units of Minutes/Seconds. Determines
the time required before the ModSync® will disable a lag boiler after it has
reached its disable point.
ƒ
Lead Boiler Start Deviation:
Defines how many degrees below setpoint
before the ModSync® will enable the lead boiler.
ƒ
Lead Boiler Stop Deviation
: Defines how many degrees above setpoint
before the ModSync® will disable the lead boiler.
FIGURE 29 – LEAD / LAG SCREENS PAGE 2