FULTON ModSync SE, Руководство пользователя

Страница: 38 / 79

© Fulton Group N.A., Inc. 2021
3-24
OPERATION
ModSyncSE-User-Manual-211020
SECTION 3
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
limit, low water condition, or other limiting device that could prevent the
boiler from running but the ModSync® may not see.
ƒ
Monitor Alarm Retry:
If Enabled, when a boiler is locked out on a Monitor
Alarm the ModSync® will automatically clear the Monitor Alarm after the
adjustable time delay. This will allow the boiler to rejoin the sequence if an
auto reset limit is the reason for the boiler being locked out on a Monitor
Alarm condition.
ƒ
Setback Schedule
The Setback Schedule will allow the ModSync® to set different setpoint curves
based on time of day and day of week.
ƒ
Mode Change: In Auto mode the ModSync® will switch between Normal
and Setback mode based on the selected schedule for the current day.
ƒ
Mode Select:
Displays the current mode and allows the user to select the
mode when the mode is in Manual mode.
FIGURE 21 – SETBACK SCHEDULE SCREEN 1
FIGURE 22– SETBACK SCHEDULE SCREEN 2