FULTON ModSync SE, Руководство пользователя

Страница: 60 / 79

© Fulton Group N.A., Inc. 2021
4-6
NETWORK
ModSyncSE-User-Manual-211020
SECTION 4
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
ƒ SOLA Setting
From the ‘Home’ Screen select ‘Setup’ in the lower right corner, then select
‘Display Setup’ from the ‘Setup’ Menu.
Determine where the wiring for the ModSync® Port 2 communication is landed.
On a typical setup, COM 1 will be the communication from the SOLA Display to
the SOLA Base, leaving COM 2 open to communicate to the ModSync®. Select
the appropriate COM tab (see image below) and enable the port, make sure the
Modbus address you wish to use is within the defined range and select a baud
rate of 19200.