FULTON ModSync SE, Руководство пользователя

Страница: 64 / 79

© Fulton Group N.A., Inc. 2021
4-10
NETWORK
ModSyncSE-User-Manual-211020
SECTION 4
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
Fulton PURE Control™™ Setup
1. Wiring for the ModSync® to the PURE Control™™ is landed on the A, B, C
terminals for the modbus connection. *Note that you must also remove
the BMS1/BMS2 jumper in each boiler before the boiler will respond
properly.
2. To set the Modbus address Press and hold the screen in the top right
corner until the drop down menu appears and select ‘UniApps’.
3. Login using the information provided by Fulton or your Local Rep.