Fukuda Denshi DS-8400, Руководство по обслуживанию

Страница: 17 / 274

xiii
Precautions for Using the Equipment
This System
 When connecting to other equipments, contact your nearest representative.
Danger such as electric shock may result to the patient and operator.
Warnings about the System
 Do not connect any equipment or cable not authorized by Fukuda Denshi to any I/O connector. Also, do not
connect any damaged equipment or cable. If done so by mistake, not only that the equipment cannot deliver its
maximum performance, the equipment may be damaged and safety cannot be ensured.

If the equipment is used under an environment not fulfilling the specified condition, not only that the equipment
cannot deliver its maximum performance, the equipment may be damaged and safety cannot be ensured. If
using the equipment under condition other than specified, contact your nearest representative.
 Use only the supplied 3-way AC power cable. Use of other cables may result in electric shock to the patient
and the operator.
 The power cable must be connected to a hospital grade outlet.
 When using multiple ME equipment simultaneously, perform equipotential grounding to prevent potential
difference between the equipments. Even a small potential difference may result in electric shock to the patient
and the operator.
 Carefully route the cables to avoid patient entanglement and strangulation.
 When lifting this equipment, hold the bottom part of the main unit and not the display unit.
 Damage to the LCD may cause leakage of liquid crystal. In such case, do not touch the leaked liquid crystal
with bare hands, or put it into your mouth as it may cause intoxication. If the liquid crystal accidentally enters
the eyes or mouth, wash off immediately with water and consult a physician.
 When attaching the display unit to the main unit, slowly insert the rail on the rear side of the display unit to the
guides on both sides of the main unit. Then, secure it with the specified screws.
Warnings about the Monitoring
 The patient classification selection influences the precision of the QRS detection and NIBP measurement.
Make sure the proper selection is made.
 The pacemaker usage setting influences the precision of the QRS detection and arrhythmia analysis. Make sure
the correct selection is made.
 If the QRS pace mask function is set to [OFF], [10ms]/[20ms], the pace pulse may be erroneously detected as
a QRS complex and HR alarm or asystole alarm may not generate due to incorrect HR (counting pace pulse as
QRS complex). Select [OFF], [10ms]/[20ms] only if you are sure that pacing failure will not occur, or when
the patient can be constantly monitored.
 When measuring the SpO
2
of patient with high fever or peripheral circulatory insufficiency, check the sensor
attachment periodically and change the attachment site. The temperature of the attachment site will rise due to
the sensor heat which may result in burn injury.
 For the following case, accurate measurement of SpO
2
may not be possible.
 Patient with excessive abnormal hemoglobin (COHb, MetHb)
 Patient with the pigment injected to the blood
 Patient receiving CPR treatment
 When a sensor is applied to a limb with NIBP cuff, arterial catheter, or intracatheter

When measuring at site with venous pulse
 Patient with body motion
 Patient with small pulse
DANGER
WARNING
WARNING