FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 461 / 628

IN1-80
IN1-80
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-05E
REFERENCE
Exposure condition examples for exposing an IP to a dose of 10 mR are shown
below. (1305SE)
SID: 215 m
Voltage: 75 kV
Amperage: 100 mA
Time: 90 msec
When the gain correction data is automatically generated and stored in the HDD,
“Succeeded” appears after completion.
u
NOTE
u
If “NG” appeared, check the following.
- Exposure condition
- Exposure field is the entire SE.
u
NOTE
u
If the calibration freezes in the above procedures, restart the SE and the MC,
then re-execute from the SEs whose connections have been checked.
(3) Click [OK].
1200_700548E.ai
(4) Click [Next].
NOTE
Do not perform defect calibration and lag calibration when installing.
11.3 Checking the Calibration Results
The calibration results can be checked after the calibration.
(1) Click [Backup] in the “SE Correct Data Backup/Restore” in the
“BACKUP/RESTORE”, and back up the SE correction data.
1200_700558E.ai
REFERENCE
To backup correct data of multiple SEs together, click [Backup Package].
(2) Open the files written below with the Word Pad.
- Gain calibration: PanelCorrectSensitivity.txt
If the number is other than 150,8000: Restoration of the serial number is
successful.
If the number is 150,8000: Compare with machine-specific CD and confirm
that time stamp and contents are the same. If they are the same, the machine-
specific has been successfully restored. If it is different, restoring the machine-
specific has failed, so install the machine-specific again.
u
INSTRUCTION
u
Perform the procedures from “11.1_Offset Calibration” to “11.3_Checking the
Calibration Results” at an installation site where two or more SEs are connected.
{IN1:11.1_Offset Calibration}