FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 598 / 628

AppxIN5-2
AppxIN5-2
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-05E
Appendix 5.1 DR Maintenance Software
Appendix 5.1.1 Defect Calibration
CAUTION
Keep to the exposure interval defined in the Operation Manual of the X-ray high
voltage generator when making continuous exposures. An interval of 1 minute
or longer normally needs to be taken.
u
NOTE
u
- When performing the defect calibration after the gain calibration, do not move
the tube. Keep the same position of the tube as when the gain calibration was
performed. If the tube position is changed, a line defect is wrongly detected at the
upper and lower ends of the CENTER panel unit. This may cause an artifact or a
defective at the boundary of the panel unit.
- If an artifact has occurred, take the following measure.
- For TOP panel unit or BOTTOM panel unit
Perform the full calibration for the target panel unit.
- For CENTER panel unit
Perform the full calibration and marker calibration.
REFERENCE
The focal size of the X-ray high voltage generator may be either large or small.
(1) Select a SE to be calibrated and set an operation with “Operation
Setting”, and then click [START] of “Defect Calibration”.
1200_700534E.ai
u
NOTE
u
If you click [START] during automatic offset update (for 30 seconds every approx.
10 minutes), “Error 12700 currently unavailable” appears. Click [START] again
after an interval of approx. 30 seconds, in this case.
REFERENCE
Whether the calibration is successfully completed appears after completion.
An error code is displayed in some cases. Refer to the Troubleshooting manual
and take appropriate countermeasures.