FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 305 / 628

MU2-40
MU2-40
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-02E
[6.2] Gain Calibration >>

Display Window
DRID600_G0095E.ai
#1
Gain Calibration >> window
#2
#1 Input: Target SE No.
#2 Click: [SET]

Function Description
Gain calibration takes place under the following conditions:
- Exposure conditions: Tube voltage of 75 kV, dose of 10 mR
- Exposure count: 16
u
NOTE
u
- Do not change the tube position in the gain calibration. If the tube position is
changed, a line defect is wrongly detected at the upper and lower ends of the
CENTER panel unit. This may cause an artifact or a defective at the boundary of the
panel unit.
- If an artifact has occurred, take the following measure.
- For TOP panel unit or BOTTOM panel unit
Perform the full calibration for the target panel unit.
- For CENTER panel unit
Perform the full calibration and marker calibration.
u
NOTE
u
- Be sure to make sixteen exposures after you click [Start]. Then click [Create a
Gain Data]. Processing cannot be terminated, waiting for data generation, if you
click [BACK] without clicking [Create a Gain Data]. Return to the “Gain Calibration”
window and again follow the procedures in this case.
- If you click [Create a Gain Data] before you make sixteen exposures, “error code”
is displayed in the result display area. If “error code” appears, continue to make
exposures, and click [Create a Gain Data] after you have made sixteen exposures.
- Clicking [Start] during automatic offset update (always taking place approx. at
10-minute intervals when no exposure menu is selected), “Error 12700 currently
unavailable” is displayed. Again click [Start] approx. 30 seconds later in this case.
REFERENCE
Whether the check is successfully completed appears on the result display area.
An error code is displayed in some cases. Refer to the Troubleshooting manual and
take appropriate countermeasures.