FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 459 / 628

IN1-78
IN1-78
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-05E
u
NOTE
u
If you click [START] during automatic offset update (for 30 seconds every approx.
10 minutes), “Error 12700 currently unavailable” appears. Click [START] again
after an interval of approx. 30 seconds, in this case.
REFERENCE
Whether the diagnosis is successfully completed appears on the result display
area.
An error code is displayed in some cases. Refer to the Troubleshooting manual
and take appropriate countermeasures.
u
NOTE
u
If the calibration failed, restart the SE and retry from connection check.
(2) Click [OK].
(3) Click [Next].
11.2 Gain Calibration
CAUTION
Keep to the exposure interval defined in the Operation Manual of the X-ray high
voltage generator when making continuous exposures. An interval of 1 minute
or longer normally needs to be taken.
INSTRUCTION
- In the case where the machine-specific data is installed into a fresh installation of
the MC software V12.0 or later, perform the gain calibration on the CENTER panel
unit.
- In the case where the MC software is upgraded from V11.0 or earlier to V12.0
or later, the gain calibration has been performed under the MC software V11.0
or earlier. Therefore, perform the gain calibration on all of the panel units (TOP,
CENTER and BOTTOM).
u
NOTE
u
- Do not change the tube position in the gain calibration. If the tube position is
changed, a line defect is wrongly detected at the upper and lower ends of the
CENTER panel unit. This may cause an artifact or a defective at the boundary of the
panel unit.
- If an artifact has occurred, take the following measure.
- For TOP panel unit or BOTTOM panel unit
Perform the full calibration for the target panel unit.
- For CENTER panel unit
Perform the full calibration and marker calibration.
REFERENCE
The focal size of the X-ray high voltage generator may be either large or small.