FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 540 / 628

IN2-63
IN2-63
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-04E
(8) Select “CONFIG - NETWORK CONFIG - ALL OTHER NODES” and click
[NEW].
The New Node window opens.
#1 Select: ALL OTHER NODES
#2 Click: [NEW]
1200_700140.ai
Setup Configuration Item window
#1
#2
(9) Make the following settings and click [OK].
NOTE
The IP address to be entered in “IP Address” depends on the installation
destination of the MC application.
- To install in the DX Console: 127.0.0.1
#1 Input: HostName and IP Address (127.0.0.1)
#2 Select: CU/MC
#3 Click: [OK]
1200_700144.ai
New Node window
#1
#2
#3
10.8 Setting the Serial ID of the SE
INSTRUCTION
- Take the procedures from “10.7 Setting the Serial ID of the SE” to “10.10 Setting the
IP Address of the SE” with connecting only one SE.
- For making the setting of the second SE, replace the SE after the setting of the first
SE is completed.
NOTE
- If two SE’s are connected, set the serial ID after one of them is removed. The default
IP address (IP address when shipped out from the factory) which is registered in
the SE is the same (192.168.0.90 to 92) for all SE’s. If two SE’s are connected
therefore, the SE cannot be identified due to the duplicate address, resulting in an
error.
- Always turn OFF the MP power before installing/removing the SE.