Force SYS68K/CPU-30 R4, Техническое справочное руководство

Страница: 148 / 209

SYS68K/CPU-30 R4 Technical Reference Manual VMEPROM
Page 135
7 Concept of VMEPROM
7.1 Getting Started
After power up or after RESET has been pressed, VMEPROM prints a
banner showing the version and revision being used and prints the prompt
("?").
If the above message does not appear, check the following:
1. Baud rate and character format setting of the terminal (default upon
delivery of the CPU board is 9600 Baud, 8 data bits, 1 stop bit, no
parity).
2. Cable connection from the CPU board to the terminal.
3. Power supply, +5V, +12V, -12V must be present.
SEE ALSO: Refer to Section 2.5, ‘Serial I/O Channels,’ on page 21 and
to Section 3.9, ‘The DUSCC 68562,’ on page 58 for the pinning of the D-
Sub connector and the required handshake signals.
See Table 1, “Specifications for the CPU-30 R4 Board,” on page 7 for the
power consumption of the CPU board.
If everything goes well, the header and prompt are displayed on the
terminal and VMEPROM is now ready to accept commands.
7.2 Command Line Syntax
All valid VMEPROM commands consist of the following:
or
The underlined areas must be entered by the user. If more than one
parameter will be entered, they must be separated by a space or a comma.
For a detailed description of all functions of the command interpreter
please refer to chapter 3 of the VMEPROM User's Manual.
? command<cr>
? command parameters<cr>
☞