Flexim FLUXUS G722ST-HT, Руководство по эксплуатации

Страница: 89 / 175

9 Measurement
FLUXUS G722ST-HT 9.2 Measurement settings
89
UMFLUXUS_G722ST-HTV1-2EN, 2021-09-01
Tab. 9.1: Configuration of the outputs
source item list item output
Flow quantities Flow velocity flow velocity
Operation vol. flow operating volumetric flow rate
Mass flow rate mass flow rate
Totalizers Volume (+) totalizer for the volumetric flow rate in positive flow direction
Volume (-) totalizer for the volumetric flow rate in negative flow direction
Volume (Δ) difference of the totalizers for the positive and negative flow direction
Mass (+) totalizer for the mass flow rate in positive flow direction
Mass (-) totalizer for the mass flow rate in negative flow direction
Mass (Δ) difference of the totalizers for the positive and negative flow direction
Fluid properties Fluid temp. fluid temperature
Fluid pressure fluid pressure
Fluid density fluid density
Kin. viscosity kinematic viscosity
Dyn. viscosity dynamic viscosity
Compress. coeff. gas compressibility coefficient
Event trigger R1 limit message ( Event trigger R1 )
R2 limit message ( Event trigger R2 )
R3 limit message ( Event trigger R3 )
R4 limit message ( Event trigger R4 )
Diagnostic values Crest factor signal-to-noise ratio for the cross correlation function
Transducer temp. transducer temperature
Miscellaneous Custom. Input 1 measured values of input quantities (e.g., temperature, density) which are
not used for calculation
In the menu item
Options\Assign inputs it is possible to assign
configured inputs to customized inputs.
Custom. Input 2
Custom. Input 3
Custom. Input 4