Kalea Bay LED Outdoor Fireplace
REV. B Page 19
Step 7:
If needed, remove the screws from the “bottom
end” of the burner pan area to provide additional room
for wiring the LED lights. The “bottom end” fills the space
between the burner pan and the fireplace side panel. It
is held into place with three (3) screws. See Fig. 22. First
remove the two inside screws, then the screw securing the
side wall. Lift up the area where the two screws were and
push down where the single screw was, then lift the
bottom end out of the fireplace.
Step 8:
Using Fig. 23 below, insert the LED channel
assembly female connector (protruding through the wire
grommets) to the LED male connector 77110.
Note:
The
male end of the LED connector will only insert into the
female connector in one direction. Once locked in
position, screw the threaded cap of the female connector
securely over the male connector.
Step 9:
Attach 77110 to 77111 using the molex
connectors. After connecting the LED lights into the 77111
wire harness insert the 12-volt adapter 77102 with
¼”
terminals) into the (red & black wires) of LED wire
harness. Plug the 12-volt adapter into the 120VAC GFCI
box with weather proof cover. See Fig. 26, page 21.
Step 10:
Re-install the “bottom end” if applicable.
LED LIGHTING INSTALLATION
Bottom End
1. Remove Screws
2. Lift up
3. Push down
V+
LED Lights
Male
Female
Female
Male
LED Lights
From
Fireplace
L
ore
Inside Fireplace
LED Light Connection
12-volt adaptor;
6-foot long
#77102
24-inch LED Wire Harness
#77110
10-foot LED Controller Wire
Harness #77111
Connects to RGB Control
Assembly (dimmer and switches)
Female
Male
Female
Male
Male
Female
Fig. 22
Removing bottom end
Fig. 23
LED wire connection
