Fimer FMR-PVS-10-TL-SX, Руководство по эксплуатации продукта

Страница: 51 / 80

EN
51
6. Instruments
6.1 General conditions
The first rule to prevent damage to the equipment and to the operator is to have a thorough knowledge of the instruments. We, therefore,
advise that you carefully read this manual. If you are not sure about any information in this manual, please ask FIMER Service for more
detailed information.
FORBIDDEN –
J Do not use the equipment if:
- you do not have suitable qualifications to work on this equipment or similar products;
- you are unable to understand how it works;
- you are not sure what will happen when the buttons or switches are operated;
- you notice any operating anomalies;
- there are doubts or contradictions between your experience, the manual and/or other operators.
ATTENTION –
A
FIMER cannot be held responsible for damage to the equipment or the operator if it is the result of lack of knowledge,
insufficient qualifications or lack of training.
6.2 Description of synoptic
The synoptic (03) is located on the front cover of the inverter and consists of 4 LED icons
03
POWER
Indicates that the inverter is functioning correctly.
When the unit is commissioned, while the grid is checked, this icon blinks. If a valid grid voltage is detected, the icon remains continuously
lit, as long as there is sufficient sunlight to activate the unit. Otherwise, the icon will continue to blink until the sunlight is sufficient for
activation.
WLAN/LAN
Indicates the status of the Wi-Fi or Ethernet communication lines.
ALARM
Indicates that the inverter has detected an anomaly. This type of problem is highlighted in the Web User Interface and FIMER Installer
for Solar Inverters APP.
GFI
The “GFI” (ground fault) indicates that the inverter has detected a ground fault in the DC side photovoltaic generator. When this fault is
detected, the inverter immediately disconnects from the grid.
NOTE –
D The icons, in various multiple available combinations, can signal multiple conditions other than the original single condition;
see the various descriptions explained in the “LEDs behaviour” paragraphs on this manual.