FBII XL-20, Инструкции по подключению и установке

Страница: 24 / 83

6–1
S E C T I O N 6
System Operations
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Power Up/System Reset
(The following System Stabilization mode statement is True for the Armed state only.)
SYSTEM STABILIZATION MODE: Upon initial power-up of the system, all of the
lights on the LED keypad(s) will go ON and then go OFF for approximately 2 min.
10 secs (if system was previously armed). This occurs on a total power-up, system
reset or after completion of system programming. If the total system power is lost,
upon power restoral the system will return to the previous arming state. The 2
min. 10 secs. interval is used to allow motion detectors (in interior zones) to
stabilize on power-up in order to prevent false alarms. THIS OPTION CAN BE
DISABLED BY PUTTING A MOMENTARY JUMPER BETWEEN TERMINAL 15 AND
16 ON POWER-UP. IF DISABLED, THE POWER-UP RESET TIME IS
APPROXIMATELY 5 SECONDS. This is a normal condition.
Arming the System
The system can be armed only if all burglary zones are not faulted. On LED-based keypads,
this requires that the READY LED be on. Arm faulted is only allowed for Delay or Interior
zones if programming question 05 is set to 2.
TO ARM: Enter any programmed 4-digit user. NOTE: The factory default for User no. 1 is
1234.
The ARMED LED will light and the user may exit through an exit/entry zone for the time
period programmed as the exit delay. The system can be armed without the backup battery
being connected, however the AC/LB light will flash.
Stay Arming
TO ARM: Press the STAY button followed by a four-digit user code.
The ARMED and STAY LEDs will light on LED-based keypads.
The system is armed at this time, with all programmed Stay zones excluded.
Stay/Instant Arming
TO ARM: Press the INSTANT button then the STAY button and a 4-digit User code.
The INSTANT STAY mode will arm the system with the characteristics of both the
INSTANT and STAY modes. The system will be armed with the interior zones bypassed and
the delay zones instant.
LED keypads will have the ARMED, STAY and INSTANT LEDs lit. NOTE: This option is
enabled in programming question 05, location 2.
Disarming
TO DISARM: Press any valid 4-digit User code and the ARMED LED will extinguish.
If an Alarm condition exists or occurred while the system was armed, the zone LED(s) and
the READY LED will be blinking rapidly. This ALARM MEMORY condition can be cleared
by entering a valid User code or using the asterisk (*) key, if programmed.