FBII XL-20, Инструкции по подключению и установке

Страница: 61 / 83

XL-20 Hookup and Installation Instructions
11–2
Question Numbers = Zone LEDs
Zone LEDs 1 through 5 display the current QUESTION NUMBER (not the specific location
within each question). In the diagram above, the question number is the total you get when
you ADD the values of all LEDs that are ON.
Examples:
Zone 1 ON, Zones 2-5 OFF = Question 01
Zone 1 ON, Zone 2 ON, Zones 3-5 OFF = Question 03
Zone 2 ON, Zone 3 ON, Zone 4 ON, Zones 1 and 5 OFF = Question 14
Location Contents = System Status LEDs
The remaining status LEDs (STAY, INST, TX LB and RF SPRV) display DATA that resides
in each location within the current question. As shown in the diagram above, the value
located next to each LED that is on must be ADDED to calculate the total data for each
location.
Examples:
Stay ON, Inst, TX LB and RF Sprv OFF = 1
Stay and Inst ON, TX LB and RF Sprv OFF = 3
Inst and RF Sprv ON, Stay and TX LB OFF = A
The following chart shows binary values that you will see on these LEDs for the letters A-F
that may be entered in some locations of the program sheet.
A 10 Inst & RF Sprv ON
B 11 Stay, Inst, & RF Sprv ON
C 12 TX LB, & RF Sprv ON
D 13 Stay, TX LB, & RF Sprv ON
E 14 Inst, TX LB & RF Sprv ON
F 15 Stay, Inst, TX LB, & RF Sprv ON
How to Enter Data
This section of the manual describes the physical keystrokes to enter the data written on the
program sheet.
Movement Between Questions
System Program mode starts with question 1 displayed. DIRECT JUMPS TO ANY
QUESTION CAN BE MADE BY PRESSING THE * (ASTERISK) BUTTON AND THE 2-
DIGIT QUESTION NUMBER.
Questions can be accessed directly or sequentially.
Example: To jump to question 07, Press * 0 7
The question number will be displayed by the zone LEDs. The status LEDs will display the
contents of the FIRST location in that question.
Movement Within Questions
The zone LEDs display the question number and the other status LEDs display the contents
(data) within each location. MOVEMENT FROM LOCATION L1 TO THE NEXT LOCATION
WITHIN ANY QUESTION CAN BE PERFORMED BY PRESSING THE # (POUND)
BUTTON.
The other status LEDs will display the contents of each location as this button is pressed.
Data Entry
To alter the value in any location, enter the desired DIGIT from the program sheet, and
press the # button.