FBII XL-20, Инструкции по подключению и установке

Страница: 26 / 83

Section 6 - System Operations
6–3
This feature is ALWAYS enabled.
Manual Unbypass
This function removes an existing bypass from a currently bypassed zone. The procedure is
the same as Bypass.
User Code Programming
User codes can be entered or modified directly through the keypad. The system contains up
to six User codes (4 digits each) with the following applications:
USER
NUMBER
APPLICATION
DEFAULT
CODE
1 Master User (see note 1) 1234
2 Normal User NULL
3 Normal User NULL
4 Normal User NULL
5 Arm Only (see note 2) NULL
6 Ambush (see note 3) NULL
NOTES:
1. User Number 1 - programs all user codes (1-6); cannot be deleted.
2. User Number 5 - can be programmed as an arm-only user in question 05, location 4.
This means that the User code can only arm but not disarm the system. Typically, this
would be used for a maid service or any person with temporary access.
3. User Number 6 - can be programmed as an Ambush code if there is an Ambush CS
transmission code programmed into question 19, locations 1 & 2. In this mode, entry of
the User number 6 code will ARM or DISARM the system and transmit the ambush
code to the central station. Furthermore, if opening/closing by User reporting is
programmed, User number 6 will be reported along with the Ambush code. If no CS
code is defined in question 19, then User number 6 will be a normal User code.
TO ADD or CHANGE USERS: [CODE] [USER] [USER #] [USER ID]
Where:
[CODE] Press CODE button
[USER] Enter Master User ID code (User no. 1)
[USER #] Press desired user to be programmed (1-6)
[USER ID] Enter new 4-digit User code. Valid digits are 0-9
Example: Define User no. 3 with an ID of 7493. (Assume Master User code is 1234).
[CODE] 1234 3 7493
An acknowledgment sound (steady tone) verifies a successful User code programming. A
negative acknowledgment sound (4 short tones) indicates unsuccessful programming.
If additional user programming is necessary, repeat the procedure listed above. If a dialing
format that transmits opening/closing by user ID is programmed, each user will report the
respective user number.
User code programming can be performed ONLY while the system is DISARMED.
User Deletion
User codes (2 - 6) can be deleted directly through the keypad. Once deleted, their values will
be null.