FBII XL-20, Инструкции по подключению и установке

Страница: 48 / 83

Section 9 - System Programming
9–15
24-Hr. Zones
FIRE - FIRE zones on the system contain Fire Verification Logic. Upon detection of the first
violation, smoke detector power will be reset for a period of 8 seconds. After this time period,
power is restored. For 5 seconds the fire zone will not be scanned, allowing the smoke
detectors to settle. Future violations within a two-minute period will result in a PULSING
BELL OUTPUT, RAPID PULSING ZONE LED, and IMMEDIATE transmission to the CS.
Fire signals cannot be aborted.
Entry of any valid user code will silence the sounder and bell, and reset smoke detector
power. If the system detects that the fire zone is still violated within 2 minutes after power
reset, the zone LED will pulse slowly to indicate a Fire Trouble. Thereafter, smoke detector
power will be reset every 4 minutes automatically in an attempt to clear the fire zone.
In the event the fire zone experiences an Open, the system indicates Fire Trouble by pulsing
the keypad zone LED and sounder slowly. The system Trouble code (followed by the Zone
code) will be reported to the CS.
The keypad sounder can be SILENCED through entry of ANY VALID USER CODE. NOTE:
FIRE ZONES cannot be bypassed.
24-HR. ALARM - This zone type is always active, independent of the system arming status.
Programming options include audible (STEADY BELL) or silent (NO BELL or keypad
indications). Upon violation, the zone LEDs will pulse rapidly (audible zones only) and an
immediate CS transmission will occur which cannot be aborted.
24-Hour Alarm zones can be bypassed; however, they cannot be unbypassed if a violation
exists on the zone terminals.
24-HR. TROUBLE - This zone type is always active, independent of the system arming
status. Programming options include audible (PULSING KEYPAD SOUNDER) or silent.
Upon violation, the zone LED will pulse slowly. Trouble condition must exist for 15 seconds
before a transmission will occur. The keypad display and sounder will clear upon zone
restoral.
24-Hour Trouble zones can be bypassed; however, they cannot be unbypassed if a violation
exists on the zone terminals.
NOTE: 24-hour Trouble is not to be used for Fire and Burglary Detection zones. 24-Hour
Silent Alarm zones are not to be used for perimeter protection. THE SOUNDER MAY BE
SILENCED THROUGH ENTRY OF ANY VALID USER CODE.
Zone Alarm Codes
As previously specified, locations L3 and L4 of the zone questions represent the Alarm code
that will be reported to the central station.
NOTE: Zones will transmit to the central station unless these digits are defined as
AA for any individual zone; or unless the local dialer option is selected for all
zones in question 04, location 3.
Based on the dialer format selected, enter the Alarm code as follows:
STANDARD FORMAT (3X1 or 4X1): Enter the desired single-digit Alarm code in
location L3 for the specific zone. The value placed in L4 will not be used.
EXTENDED (3X1 Ext. or 4X1 Ext.): Enter the desired first digit of the Alarm code for
the specific zone, in location L3 and the second digit in L4.
PARTIAL EXTENDED (3X1 Part. Ext. or 4X1 Part. Ext.): Enter the desired digit in
both locations L3 and L4 for the specific zone. This will generate a single-digit
transmission for Alarms and Troubles (the second digit will not be used) and an extended
transmission for all system conditions such as Restores, Bypasses, Openings/Closings, etc.
(the second digit will be used).