FBII XL-20, Инструкции по подключению и установке

Страница: 32 / 83

Section 8 - Installer Modes
8–3
to complete the request while on-line. No additional telephone call is needed. On-line
connection can be made as follows:
1. After completing the installation, attach a handset to the telco terminals (tip and ring) or
uses the standard home telephone to dial the CS downloading modem telephone line.
Connection is made with a person at the CS downloading computer and the account to be
downloaded is verbally identified. The downloading computer operator selects “On-line
Remote Operations” from the Device menu.
2. Enter the on-line download sequence: [CODE] [*] [INSTALLER] [4] or use the end-user
command of [#] [9], if enabled. This will cause the control panel to behave as if it received
a request for a remote communications session, and to look for the standard panel to CS
protocol.
3. Once the standard connection is made, the necessary remote communications sessions can
take place (Upload, Download, and Remote commands).
4. Hang up the telephone or remove headset from the line to prevent interference that may
affect upload/download data. The downloader software will automatically terminate the
connection after remote communications end.
Installer Mode 5 (Walk Test - Reduced Gain Mode)
This mode tests the RF receiver in a Reduced Gain mode. This mode is maintained until the
[STAY] key is pressed. The keypad displays this mode by pulsing the Arm, AC and Ready
LEDs. A LED that is steadily ON indicates the zone that is currently faulted. A blinking
LED indicates the zone has restored. The keypad sounder is activated on faulting and
restoring of zones. To exit, press the [STAY] key to cause a complete system reset.
All RF zones must be returned to normal before exiting Walk-Test mode (i.e., doors and windows
should be closed). If these RF zones are not returned to normal, they will be displayed as normal
even though they are actually faulted.