FBII XL-20, Инструкции по подключению и установке

Страница: 59 / 83

XL-20 Hookup and Installation Instructions
10–2
Questions 01-10, L2 - RF Device Type
Digit TYPE EXPLANATION
0 DISABLED NOT APPLICABLE
1 5800 Transmitter 5800 Series Transmitters (Select for Keyfobs)
9 5816 Transmitter 5816 Transmitter using magnetic relay only
Questions 01-10, L3 through L9 - 5800 Serial Number
Enter the 7-digit Serial Number printed on the device for all 5800 RF devices to be used.
If an RF device is not to be used, program a “00” into the locations corresponding to the
device.
NOTE: When programming a device that uses multiple zones, you must skip the additional
zones supported by that device by disabling them. For example, if Zone 2 has a device that
has been programmed to support three zones, the next two zones must be disabled, and the
following zone must be zone 5.
To disable an RF point that has been previously programmed, you must:
1. Remove the RF enable for the appropriate zone in Question 26; and
2. Make the first 2 digits in the RF programming for that zone “00.”
Example of RF Programming
In this example of RF Programming assume that a four button keyfob is being enabled as
keyfob number 1, the keyfob has a serial number of “A 123 4567" and that only one question
(09) is being programmed at this time.
DESCRIPTION KEYPAD ENTRY
1. Enter RF programming *#
2. Select question 09 for keyfob 1 09
3. Select the 4 button keyfob option (table L1- RF Device Options) 4
4. Select 5800 transmitter type (table L2 - RF Device Type 1
5. Enter 7-digit serial number from the keyfob as L3 through L9
(ignore letter A at the beginning)
1234567
6. Exit RF Programming STAY
A completed RF Programming Worksheet for the above example would appear as:
09 RF KEYFOB 1 DEFINITION
Default: 000000000
1 2 3 4 5 6 7 8 9
OPT TYPE SERIAL NUMBER