FARFISA INTERCOMS Matrix Series, Руководство пользователя

Страница: 14 / 32

I
T
A
L
IA
N
O
E
N
G
L
IS
H
F
R
A
N
Ç
A
IS
E
S
P
A
Ñ
O
L
P
O
R
T
U
G
U
Ê
S
D
E
U
T
S
C
H
Mi 2437/1
14
OPERATION
Check that all connections are
correct. Connect the power supply
unit to the mains; the push-button
panel automatically checks the status
of the line displaying for 5 seconds
“TD6100MA / Rel. SW.....”;
at the end
of checking, in case of failure, the
display shows “TD6100MA / ERROR.
....”
in case of a positive check on the
display appears the message “Dial
the number or press
"
( in
alternate mode).
Dial the number or select the desired
user name (if previously stored) by
pressing the
or buttons, once
the desired user name appears on
the display press the
to make a
call.
In case of error press (only before
sending the call) and dial the correct
to number.
If the line is free you will hear the
confirmation tone and the display
shows “Call /----”; the internal station
rings the number of times defined by
system programming.
If press the call is terminated and
the system is ready for a new call.
The called user picks up the handset
enables the conversation with the
external station for 60 seconds. The
display shows “Connection /---- ”.
The display of the door station starts
flashing 10 seconds before conver-
sation ends. To continue conversa-
tion for additional 60 seconds press
again (up to 3 times).
From the internal station, press the
button to release the door lock;
this operation requires that the user
is in conversation and wait about 1
second after lifting the handset. The
lock release activation time is de-
fined by programming "door lock
activation time"
(code 10 - page 13).
Replace the handset or press on
the door station to restore the idle
state.
Numbers that are not sent or deleted
go off after 25 seconds.
In installations with
2 or more main
push-button panels , when a call is
made from one push-button panel,
the other push-button panels are
deactivated with the busy signal. Wait
until the line is free to make the call.
Door lock opening
The door lock can be opened from the
push-button panel, including in “busy”
mode, by dialling one of the 80 4-digit
passwords you have entered.
Door lock activation
- On the keyboard dial 00
- Press ; the display shows
“Password / “
- Dial the personal access code within
10 seconds; each digit is visualized
with * instead of .
- Press to release the door lock;
you hear the confirmation tone and
the push-button panel returns to the
current system operation mode (free
or busy).
If properly programmed you can
access the door lock opening function
with the following simplified procedure
(see note 1 on page 12):
X + Pa
0 1 2 3 4 5
0 1 2 4 5 6
0 1 2 5 6 7
0 1 2 4 5 6
0 1 2 3 4 5
Calling tone table
Call no. 0
Call no. 1
Tone table
Dialling.
Invitation to dial
0 1 2 3 4 5
0 1 2 3 4 5
Busy. The called user is busy
Dissuasion.
Indicates that a wrong code was
dialled (higher than 250)
Warning.
Indicates that conversation time is about
to end.
0 1 2 3 4 5
Programming.
Indicates the programming mode
Acknowledge.
Indicates that programming has
been executed.
Call no. 2
Call no. 3