Fairford Electronics QFE Series, Руководство пользователя

Страница: 7 / 194

5 M-8588-F 110620
4 Set-up examples
Starter Enable/Disable
An additional safety feature has been added so that following certain actions the starter will be disabled. It is strongly
recommended that before any changes to parameter values are made, that the starter is
disabled via the Basic Menu .
Once disabled, the starter remains unable to drive the load, until it has been enabled via the Basic Menu , or the control
supply is removed and reapplied, or the key is pressed when prompted.
2 Setting the QFE for remote starting and stopping.
With ‘Starter Disabled’ shown on the display,
press ENTER key once.
With ‘Applications’ shown on the top line of
the display press key twice until ‘Basic’ is
shown at the top of the display.
Press ENTER once to select Basic menu.
Press key twice until ‘Starting’ is shown
at top of the display then press ENTER once
to select starting option menu.
With display now indicating ‘Starting’ on top
line press ENTER to toggle from ‘Keypad
Starting’ to ‘Remote Starting’ as shown on
bottom line of display.
At any of the above stages pressing
#
will
return the user to the previous menu.
The QFE will now start and stop remotely from the START and STOP switches shown in Figure 2.1, but will return to
keypad starting if the control supply on terminals X1 and X2 is removed. Alternatively, to return to keypad starting and
stopping, repeat the above procedure and select
‘Keypad Starting’ at step 5. To keep the remote start/stop setting
after removal of the control supply, the settings must be permanently saved (See 3 below).
E NT E R
# # #
E NT E R E NT E R E NT E R
E NT E R
1 Setting the QFE for large pump application
With ‘Starter Disabled’ shown on the display, press ENTER key once.
With ‘Applications’ shown on the top line of the
display press ENTER once.
With ‘Settings’ shown at the top of the display
press key three times until ‘Large pump’ is
shown at top of display.
Press ENTER once to select large pump. The
display will indicate the parameters changing in
short intervals.
With the display top line indicating ‘Send to store?’ ,
press ENTER to save the settings for a large pump
to permanent store. Display will flash the message
‘Storing’ twice to indicate this has been done.
At any of the above stages pressing # will return
the user to the previous menu. The QFE will not start until the control display indicates ‘Stopped and ready’.
E NT E R
# # #
E NT E R E NT E R E NT E R
3 Permanently saving parameters set by user.
With ‘Starter Disabled shown on the display, press ENTER key once.
With ‘Applications’ shown on the top line of the
display press key until ‘Permanent Store’ is
shown at top of display.
Press ENTER once to select Permanent Store
menu.
With ‘Save Param’ shown at top of display press
ENTER once to permanently save parameters.
Display will flash twice to indicate this has been
done.
At any of the above stages pressing
#
will return
the user to the previous menu.

ƒ
„
‚
Stopped and ready
1
: To Enable
6
Applications
Auto features
Save parameter
Power on param
E NT E R
# #
E NT E R E NT E R
Permanent store
Password