Extreme Networks ExtremeWare 7.5, Справочник по командам

Страница: 367 / 2546

configure protocol add
ExtremeWare 7.5 Command Reference Guide 367
configure protocol add
configure protocol <protocol_name> add <protocol_type> <hex_value>
{<protocol_type> <hex_value>} ...
Description
Configures a user-defined protocol filter.
NOTE
This command is available only on the “i” series switches and the Summit 400-48t.
Syntax Description
Default
N/A
Usage Guidelines
A maximum of 15 protocol filters, each containing a maximum of six protocols, can be defined.
The protocol filter must already exist before you can use this command: use the
create protocol
command to create the protocol filter.
On the “i” series switches , all fifteen protocol filters can be active and configured for use. On the
Summit 400-48t switches, no more than seven protocols can be active and configured for use.
Example
The following command configures a protocol named Fred by adding protocol type LLC SAP with a
value of FFEF:
configure protocol fred add llc feff
History
This command was first available in ExtremeWare 1.0.
This command was added to the Summit “ e ” series of switches in ExtremeWare 7.2e.
protocol_name Specifies a protocol filter name.
protocol_type Specifies a protocol type. Supported protocol types include:
•
etype
– IEEE Ethertype.
•
llc
– LLC Service Advertising Protocol.
•
snap
– Ethertype inside an IEEE SNAP packet encapsulation
.
hex_value Specifies a four-digit hexadecimal number between 0 and FFFF that represents:
• The Ethernet protocol type taken from a list maintained by the IEEE.
• The DSAP/SSAP combination created by concatenating a two-digit LLC Destination SAP
(DSAP) and a two-digit LLC Source SAP (SSAP).
• The SNAP-encoded Ethernet protocol type.