Extreme Networks ExtremeWare 7.5, Справочник по командам

Страница: 718 / 2546

718 ExtremeWare 7.5 Command Reference Guide
Commands for Status Monitoring and Statistics
configure transceiver-test failure-action
configure transceiver-test failure-action [log | sys-health-check]
Description
Configures the action the switch takes if too many failures are detected within the specified window.
NOTE
This command is available only on modular switches.
Syntax Description
Default
Log
Usage Guidelines
If you select
log
, only one instance of an error message is logged at this level.
If you select
sys-health-check
and the switch detects too many failures, the switch takes the
configured system health check action. To configure the system health checker, use the
configure
sys-health-check alarm-level
or the
configure sys-health-check auto-recovery
command.
The alarm-level and auto-recovery options are mutually exclusive; configuring an alarm level disables
auto-recovery, and configuring auto-recovery overrides the alarm-level setting.
By default, the switch checks for errors within the last eight 20-second windows. Use the
configure
transceiver-test window
command to modify the number of windows.
To determine if you have the transceiver test enabled and the failure action the switch takes, use the
show switch
command. The following is sample transceiver test output:
Transceiver Diag: Enabled. Failure action: log only
For ExtremeWare 6.2.2b108:
The default is
sys-health-check
, and the switch takes the configured system health check action.
Example
The following command configures the switch to perform the configured system health check action if
too many failures are detected:
configure transceiver-test failure-action sys-health-check
History
This command was first available in ExtremeWare 6.2.2b108.
log Specifies that messages are sent to the syslog.
sys-health-check Specifies that the configured system health check action is taken.