Extreme Networks ExtremeWare 7.5, Справочник по командам

Страница: 884 / 2546

884 ExtremeWare 7.5 Command Reference Guide
Security Commands
Default
N/A
Usage Guidelines
Route map
set
statements are evaluated after
match
statements, but before the
goto
statement.
When you change the route maps used to modify or filter NLRI information exchanged with neighbors,
these changes are immediately effective on the routing information exchanged after the policy changes.
The changes can be applied on the NLRI information that had been exchanged before the policy
changes by issuing a soft reset on the ingress or egress side, depending on the changes. For soft resets to
be applied on the ingress side, the changes must be previously enabled on the neighbor.
Changes to the route maps associated with network aggregation or redistribution commands becomes
effective after a maximum interval of 30 seconds. You can immediately apply them by using the soft
reconfiguration command.
Example
The following command modifies the routing information for a route that matches a statement in entry
15 of route table
bgp-out include a MED value of 200:
configure bgp-out 15 add set med 200
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available only on the “ i ” series platforms.
next-hop <ipaddress> Sets the next hop in the path attribute to the specified IP address.
internal When used in the BGP neighbor output route map, sets the MED attribute to a
value equal to the metric to reach the nexthop.
med_number Sets the MED attribute to the specified value.
remove Removes the MED attribute, if present.
add | delete <med_number> Adds or deletes the specified value to or from the MED that is received. The
final result is bound by 0 and 2147483647.
local-preference <number> Sets the local preference in the path attribute to the specified local preference
number.
weight <number> Sets the weight associated with the NLRI to the specified number.
origin [igp | egp | incomplete] Sets the origin in the path attributes to the specified origin.
tag <tag_number> Sets the tag in the route to the specified number.
accounting index
<index_number> Specifies the index number of an accounting index to be set.
value <value_number> Specifies the value to which the accounting index should be set.
cost <number> Sets the cost of the route to the specified number.
cost-type <number> Sets the cost type associated with the route (ase-type-1 or ase-type-2).