Ericsson MRS3000, Руководство по обслуживанию на месте

Страница: 21 / 159

Open information
DESCRIPTION
2 (8)
Uppgjord (även faktaansvarig om annan) - Prepared (also subject responsible if other) Nr - No.
KL/ECS/S/MK Magnus Lindahl MRS3000 Step by step programming guide
Dokansv/Godk - Doc respons/Approved Kontr - Checked Datum - Date Rev File
KL/ECS/S/MK 1997-04-16 A LZB 119 1661
STEP.DOC
The work to set-up the system software can preferably be split up into some independent parts:
1. Set-up line interface between LP200 and the attached CU200/210.
2. Make sure all units; LP200/210 and CU200/210, in the system all have the same major version
number, i.e., and the same first digit in the version number.
If you have V2.6 of LP200, you must have CU200s with version number V2.0, V2.1, V2.2 etc.
If you have V3.0 of LP200/210, your CU200s and CU210s must have version number V3.0, V3.1,
V3.2 etc. As long as the major version number is the same, the minor version number may very well
be different for each unit.
3. Radio interface, physical channel select control of radio, and logical how to handle each channel,
which channels to scan for tone-receiver etc.
4. Route information, translation between two-digit route number and corresponding channel number
and repeater-start-digit.
5. Limitations of number of concurrent squelch checked channels, (Open Traffic) and some timing.
6. Specifications of some different time-out values.
7. Set-up of the individual tone-call numbers to receive, these are, depending of call type, split into
some different subgroups.
8. Specification of different ways to dial short numbers in the CUs.
9. Signalling system specification, as default CCIR tones are used within the Swedish system
specifications "Alternative A & C".
Most of the system specification is programmed individually for RX respectively TX.