Ericsson MRS3000, Руководство по обслуживанию на месте

Страница: 120 / 159

Open information
DESCRIPTION
3 (14)
Uppgjord (även faktaansvarig om annan) - Prepared (also subject responsible if other) Nr - No.
KL/ECS/S/MK Magnus Lindahl
MRS 3000 Received Call Numbers Programmers
Guide
Dokansv/Godk - Doc respons/Approved Kontr - Checked Datum - Date Rev File
KL/ECS/S/MK 1997-04-16 A LZB 119 1661
CALL.DOC
7) Display looks like:
o F: A:
The "F" is flashing.
•
"F" is the function digit, which selects one of fifteen different received call numbers subtables. Please
refer to the chapter " How the different function digits are used " for a summary of the different function
digits.
•
"A" is the address. The digits in this field correspond to the B- digits in the signalling systems A and C
specification.
•
The entire upper row of the display is used for the phone number to dial or the destination of the call.
Please refer to the chapter " Content of the phone number/destination field " for a summary of the valid
contents of this field.
8) Enter a valid function digit, 0-9, A, B, C, D or E. In received call numbers programming mode, some
of the keys have been redefined to enable you to dial the hexadecimal digits A-E.
|Set-up| = A
|Lock| = B
|Repeater| = C
|Monitor| = D
|Control| = E
•
The "F" stops flashing, and the "A" starts flashing.
•
If there are any numbers programmed in the subtable, the first of these will be displayed.
If the subtable is empty, a short beep will sound.
•
If you want to change/clear an existing number, continue with 10) or 11). If the actual subtable
contains many numbers, it can be a good idea to continue with 12) instead.
•
If you want to add a new number, continue with 12).
•
If you want to exit programming mode, continue with 9)
9) Press |
Ü
| three times.
•
LP200/210 will reset and after a while CU200/210 will also reset.
10) Press |+|.
•
If the displayed number is the last in the subtable, the "A"-field will be cleared and a short beep will
sound, otherwise the next number in the subtable will be displayed.
•
When you have found the number you want to change, press |#| and the "A" stops flashing. Continue
with 13).
11) Press |-|.