5
3/1531-ZAP 701 14/1 Uen A 2006-10-16
AXX 9100 CONNECT R1.2 Quick Reference Guide
1.4.1
Installation Overview
You should be thoroughly familiar with the instructions in this
manual before starting any work. Use the following general order of
work when installing a site:
1.
Read and observe all safety cautions and warnings.
2.
When you arrive at the site, first verify the AXX 9100 CONNECT
equipment according to the procedures in “Pre-Installation
Procedures” on page 1 -1. If there is a problem with the
equipment, use the dedicated contact resources for your support
3.
If you do not install the equipment when it arrives, store as
specified in “Pre-Installation Procedures” on page 1 -1
4.
Unpack equipment only after preparing the site as described in
“Pre-Installation Procedures” on page 1 -1
5.
When installing equipment at a site, follow the procedures in this
chapter in the order presented.
6.
Make connections using the information in “Interconnections and
cable handling” on page 1 -20
1.4.2
Installation Planning
Based on the system to be installed, determine the size, number,
and location of racks, as well as the AXX 9100 CONNECT requires.
The AXX 9100 CONNECT will fit in 19-in. equipment racks, and can
be adapted for ETSI racks. The racks must be accessible from the
front and rear for equipment installation.
N O T E !
Recommended space of rear access for installation of the
equipment is 300 mm.
