Relay Box for Infrared Cabins - Installation Instructions
63
Commissioning
Setting the load for lighting to resistive load
1
Open the relay box’s housing as needed.
2
DANGER! Ensure that the relay box is disconnected from the power sup-
ply.
Disconnect the light source from the main circuit board.
3
Switch on the relay box and control unit.
4
Tap and hold
for 3 seconds.
5
Enter the code and confirm.
Code
8001
: Inductive load/resistive load, e.g. if light bulbs are used.
Code
8002
: Capacitive load, electrical ballasts for phase-cut dimmer.
6
Disconnect the relay box from the mains supply and reconnect the light
source.
7
Close the housing again.
5.7 Closing the relay box housing,
8
Reconnect the relay box to the power supply.
0
1 2 3
4 5 6
7 8 9
C
Setting
Code
08:44:40
01. June 2019