Relay Box for Infrared Cabins - Installation Instructions
25
Installation
2
Remove both halves of the cover.
If you have already routed all data lines, you can set the DIP switches
on the circuit board after you install the relay box.
3
Open the relay box conduits for the lines.
Either from below or from the rear.
4
Insert supplied rubber grommets into the openings of the lower part of
the housing.
Installing the relay box
1
Drill one (1) hole above and two (2) holes below.
A
Lines with mains voltage, e.g.
mains supply line, heat
B
Lines with low voltage, e.g. sensor
line, S bus (sauna bus)
Horizontal distance between drill holes: 210 mm
Vertical distance between drill holes: 180 mm
A
B
