62
Installation Instructions - Relay Box for Infrared Cabins
Commissioning
EN
4
Set the value with
and
, and then confirm.
The value can be set to any number between 1 and 5.
7.4 Defining the light source manually
The control unit is set to inductive loads by the factory so that resistive
loads can also be controlled by the control unit. If required, the light output
can also be manually set to capacitive loads.
If light bulbs are used, the load for lighting must remain as an inductive
load.
The current setting is shown on the display.
NOTICE
Material damage
Improper setup can damage the unit. In this case, the warranty be-
comes void.
Work must only be performed by a trained technician from an
authorised company specialised in the trade.
3
K
Setting
Switch. hysteresis
09:16:42
27. June 2019
Display symbol
Setting
Code
Inductive/resistive load,
if light bulbs are used.
Factory setting
8001
Capacitive load
Electrical ballasts for phase-cut dimmer
8002
R,L
R,C