Environnement MP101M, Техническое руководство

Страница: 148 / 196

Environnement
S.A
MP101M
Duplication prohibited
SEPTEMBER 2013
4–26
MAINTENANCE SHEET
Monitor serial No.:: OPERATION SHEET: 4.3.10
Scope : Contamination test PAGE : 1/1 Periodicity : 1 month
Dates
Procedure :
1/ Go to the
« TESTS

Mother board Inputs / Outputs »
.
2/ Go to
Plate
then press down the [Test] key then the [ s ] key under
Mov. Down
.
 The plate moves down. The motor stops after five seconds.
3/ Press down the [  ] key then go to
Filter
then press down the [Test] key then the [ s ] key
 The filter ribbon moves on. The motor stops after seven seconds.
4/ Press down the [

] key, then go to
Plate,
then press down the [Test] key, then the [ s ] key under
Moving up
.
 The plate moves up. The motor stops after five seconds.
5/ Press down the [  ] key, then go to
P. Source
, then press down the [Test] key, then the [ s ] key
under
Sampling
.

The source is placed into sampling position. The motor stops after five seconds.
6/ Go to the
HV Geiger
line. Then, on the
ON/OFF
field, modify the parameter into
ON
and set in
action the high voltage of the Geiger counter supply
 The counter is supplied with 600 V

100 V. The counting value is displayed on the below line.
7/ Check that the counting rate does not exceed 30 counts/s.