Enterasys SecureStack C2, Руководство по настройке, Страница: 318 / 607

Configuring Policy Class of Service (CoS)
9-16 Policy Classification Configuration
Enterasys Networks’ enhanced CoS implementation allows you to use the following methods to
configure Class of Service on the SecureStack C2:
• Allowing the switch to automatically assign policy ‐ based inbound rate limiters as described
in this section.
• Configuring transmit queueing and rate limiting on a per ‐ port basis as described in
Chapter 10 .
By default, policy ‐ based CoS is disabled on the device, and default or user ‐ assigned port ‐ based
802.1D (802.1p) settings are used to determine traffic rate limiting. When policy ‐ based CoS is
enabled, the default and user ‐ assigned policy ‐ based settings will override port ‐ based settings
described in Chapter 10 .
About Policy-Based CoS Configurations
Once enabled using the set cos state command as described in “ set cos state ” on page 9 ‐ 18, you
can add to the policy ‐ based CoS function by defining new port groupings, and assigning inbound
rate limiters. The process for user ‐ defined CoS configuration involves the following steps and
associated commands listed in Procedure 9 ‐ 1 . An example follows the procedure.
Example
This example creates different inbound rate limiters for two port groups and then assigns them to
traffic with a CoS setting of 0.
1. Configure two port groups, one for user ports and one for uplink ports and assign ports to the
groups. Port group 1.0 will represent user ports, group 2.0 will represent uplink ports.
C2(su)->set cos port-config irl 1.0 name Users ports ge.1.1-46
C2(su)->set cos port-config irl 2.0 name Uplink ports ge.1.47-48
C2(su)->show cos port-config
Inbound Rate Limiting Port Configuration Entries
----------------------------------------------------------------------
Port Group Name :Default
Port Group :0
Port Type :0
Assigned Ports :none
----------------------------------------------------------------------
Port Group Name :Users
Port Group :1
Port Type :0
Assigned Ports :ge.1.1-46
----------------------------------------------------------------------
Port Group Name :Uplink
Port Group :2
Procedure 9-1 User-Defined CoS Configuration
Step Task Command(s)
1. Enable CoS
set cos state
2. Create CoS port groups
set cos port-config
3. Define physical rate limiters for groups
set cos port-resource
4. Create virtual reference for the IRL resource
(physical reference) for each port group
set cos reference
5. Add IRL reference to CoS settings table
set cos settings