Enterasys SecureStack C2, Руководство по настройке, Страница: 111 / 607

set cdp hold-time
SecureStack C2 Configuration Guide 4-5
set cdp hold-time
Use this command to set the hold time value for CDP discovery protocol configuration messages.
Syntax
set cdp hold-time hold-time
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to set CDP hold time to 60 seconds:
C2(su)->set cdp hold-time 60
clear cdp
Use this command to reset CDP discovery protocol settings to defaults.
Syntax
clear cdp {[ state ] [ port-state port-string ] [ interval ] [ hold-time ] [ auth-code ]}
Parameters
Defaults
At least one optional parameter must be entered.
Mode
Switch command, read ‐ write.
Example
This example shows how to reset the CDP state to auto ‐ enabled:
C2(su)->clear cdp state
hold ‐ time Specifies the hold time value for CDP messages in seconds.Valid values are
from 15 to 600.
state (Optional) Resets the global CDP state to auto ‐ enabled.
port ‐ state port ‐ string (Optional) Resets the port state on specific port(s) to auto ‐ enabled.
interval (Optional) Resets the message frequency interval to 60 seconds.
hold ‐ time (Optional) Resets the hold time value to 180 seconds.
auth ‐ code (Optional) Resets the authentication code to 16 bytes of 00 (00 ‐ 00 ‐ 00 ‐
00 ‐ 00 ‐ 00 ‐ 00 ‐ 00).