19
Panel Descriptions
DISPLAY OUT Connector (p. 42)
This connector outputs an RGB signal (fixed SVGA format) The data in the F-1 (folder or
file) can be viewed when a VGA display is connected.
AUDIO IN Connector (CH3, CH4); XLR-type (p. 13)
Audio is input here. Accepts connection of audio devices and microphones.
Volume is adjusted with the [AUDIO IN Level] knob (p. 17).
Power Connector (p. 23)
This connects to the included AC adaptor using the included power conversion cable.
[HOLD] Switch
Sets the [HOLD] switch to the “ON” position so only the following buttons cannot be used
and to help prevent accidental operations.
*1 Only when power is on. If the [
(POWER)] button is pressed while power is off, the power
is turned on.
[GAIN] Switch (p. 13)
Sets the gain of the audio input from the AUDIO IN connector.
[+48V] (Phantom Power) Switch (p. 13)
Turns the phantom power supplied to the AUDIO IN connector on/off. Set to “ON” when
connecting a condenser microphone that requires phantom power.
* Supplying phantom power to a dynamic microphone may result in damage. Please thoroughly
read the instruction manual for the device that you are using. When not using a condenser
microphone requiring phantom power, please set the [+48V] switch to “OFF.”
[CH3/4] Switch (p. 13)
Set this to “ON” when capturing audio input to the AUDIO IN connectors (3CH/4CH).
Side Panel
(continued)
•
[
(STOP)]
•
[
(REC)]
•
[MENU]
•
[
(
)]
•
[
(
)]
•
[
(ENTER)]
•
[
(POWER)]
(*1)
MIC
This is set when using microphone input. You can set to this “-20 dB” to decrease micro-
phone input sensitivity. The audio input from the microphone is then decreased -20 dB.
-20dB
LINE
This is set when using line input.
F-1_v2_e.book 19 ページ 2009年4月17日 金曜日 午前10時47分