4. Installation
Rebel
80
14
Caution
Do not attempt to move the bar feeder alignment when the bar stock or the bar pusher are
extended into the lathe spindle. Damage to the bar pusher or lathe spindle may occur.
4.5
Alignment
The preferred and most precise method of bar feeder alignment is with the
Edge Technologies
Laser Alignment kit
, part number
EZ90001
by contacting Edge Technologies Parts department
at
(314) 692-8388
or email
4.5.1
Alternate method of alignment
Elevation of the bar feeder is adjusted by the two jack screws located at the center of each
stand. Loosen the four bolts securing the leg to the stand (1). Turn the jack screw (2) to raise
or lower the bar feeder center height. The side-to-side alignment is set by sliding the bar feeder
on the floor.
·
Choose a straight piece of bar stock with a diameter as close as possible to the bore of
the lathe spindle.
·
In the bar feeder parameters enter the bar length.