7. Setup Wizard
Rebel
80
34
Feeding Type: Selects between modes of feeding material in automatic.
Turret Stop:
The bar feeder begins to push when the lathe collet opens and stops pushing after
it presses against the stop. The bar feeder will use feed-out lengths 1 through 3 if set.
Position:
The bar feeder pushes the length set in the parameter Part Length 1. The bar feeder
will use the feed-out lengths 1 through 3 if set.
Sub-spindle
: The bar feeder will touch off the back end of the bar stock to measure the length
of the material and then return to the home position. It will then monitor the open collet signal
and deduct the feed length from the length of the bar stock as measured during the touch off.
When the remaining length of material is less than the part length setting the end of bar signal is
sent to the lathe.
Chucker Mode
: This setting allows the lathe to run without the bar feeder. When chosen the
bar feeder sends an auto mode signal to the lathe while remaining in the manual mode.
Turret Stop Acknowledged
: Works the same as the Turret Stop mode except that the pusher
keeps pushing until the lathe collet closes.
