2. Technical Information
Rebel
80
4
2.3
Specifications and Capacities
Bar diameter capacity
8mm to
80
mm (.315” to
3.150
”)
Maximum bar length
60” (NOT TO EXCEED SPINDLE LENGTH)
Magazine rack capacity
30” (60 ½” bars, 30 1.0” bars, 15 2.0” bars)
Bar weight
175 lbs. per bar not to exceed 1500 lbs. total
Power consumption
1 kW
Operating voltage
200-230VAC/60Hz – 3 phase
Control voltage
24VDC
Centerline height
950-1350mm (37.4” to 53.15”)
Machine footprint
84” X 48”
Machine weight
1100 lbs.
2.4
Bar Stock Requirements
Material should be relatively straight and clean. While bent stock will not necessarily cause
problems within the lathe spindle while turning, it may prevent loading if bar condition is such
that the bar collides with the back of the lathe spindle or it binds while feeding into the spindle.
Bars of small diameter may not pick up properly from the magazine if they are not straight.
Excessive chips, burrs or dirt may cause binding within the spindle.
The ends of the bar should be relatively straight to the diameter of the bar to help ensure proper
positioning of the bar as it reaches the facing position and to keep the bar pusher from sliding off
the bar while feeding the material.
Under no circumstances should a bar be run that extends past the end of the lathe
spindle! Failure to comply with this rule may result in injury or death to the operator or
personnel in the vicinity of the machine and /or severe damage to the machinery!
