6. Control Operation and Description
Rebel
80
24
6.1.3 V-Tray Up and Down Buttons
These buttons allow the operator to jog the V-Tray up and down. When jogging up the
limit of
rise
is controlled by the stock diameter listed in the parameters in the current bar feeder
program.
6.1.4 Pre-Auto and Automatic/ Manual Buttons
These buttons allow the operator to change between manual and automatic modes without
going back to the HMI each time. To place the bar feeder in automatic mode the operator must
first press the Pre-Auto button, then the Automatic button. Manual mode is selected by pressing
the Manual button alone.
6.2
Sequence for Manually Changing Bars
6.2.1 Unload bar from lathe
·
Remove the bar stock from the lathe spindle by following these steps.
·
Retract the bar pusher to the home position using the reverse jog button.
·
Raise the channel by pressing and holding the Channel Up button.
·
PUSH THE MEASURING FLAG DOWN
to prevent damage from the bar in the spindle.
·
Push the bar stock from the spindle onto the channel.
·
Remove the stock from the channel.
·
Lower the channel by pressing and holding the Channel Down button.
Auto Manual Pre Auto
V-Tray Up
V-Tray Down
