ECOFOREST ecoGEO C, Инструкция по установке и эксплуатации

Страница: 52 / 106

ecoGEO C Installation and User Manual (Version 1.0)
page 52
6 Start Up
To carry out the start-up of the heat pump, follow these steps in the order listed.
1. Fill the heating/cooling indoor circuit by following the directions in section 6.1 .
2. Fill the built in circuit coil in the DHW tank as described in section 6.2.
3. Fill the DHW tank by following the directions in section 6.3 .
4. Fill the brine circuit by following the directions in section 6.4 .
5. Fill the heat pump circuit by following the directions in section 6.5 .
6. Inspect the installation, perform the initial start-up of the equipment and verify proper operation
(see section 6.6).
6.1 Filling the heating /cooling circuit
To fill the heating/cooling indoor circuit use water only. Before starting the heat pump, make sure the air in the
cooling circuit has been completely purged, its pressure is suitable and there are no leaks in the circuit.
To facilitate filling the heating circuit start the heating pump. To do so, access SERVICE MENU -> INSTALLER
CONF. -> MANUAL CONF. -> HEATING PUMP -> STATUS, Change the value to ON.
To completely drain the heating circuit, use the heat pump drain valve at the lowest point of the circuit, just
below the heating circulator pump (see section 3.4).
6.2 Filling the built-in DHW tank coil circuit
DANGER!
During the filling of the DHW circuit, be especially careful not to get water on the electrical cabinet,
because it may cause personal injury from electric shock and/or cause equipment malfunction.
NOTE
Do not add anti-corrosion additives or antifreeze to the heating/cooling system fluid, as this may
damage the seals or other components and cause leaking.
Before filling the heating/cooling circuit, complete the electrical installation, so that the climate
control circuit pump can be used.
DANGER!
During the filling of the heating/cooling indoor circuit, be especially careful not to get water on the
electrical cabinet, because it may cause personal injury from electric shock and/or cause equipment
malfunction.